1998 Ford Contour Camshaft Removal Installation
download CAUTION: The maximum amount by which the engine management system will adjust the camshaft timing (VCT control unit) is limited to 2 degrees. As a result of this an extremely high degree of...
View Article1996 Mitsubishi Eclipse GS-T TIMING BELT & BALANCE SHAFT BELT Removal
download 1. Disconnect negative battery cable. Remove engine undercover. Place wooden block between jack and oil pan, and raise engine slightly. Remove engine mount assembly near timing belt cover. 2....
View Article1991 Mercedes Benz 300E Camshaft: Service and Repair Removing and Installing...
download CAUTION: If the camshaft is renewed, the rocker arms must also be renewed. Inductively hardened camshafts must only be used with hard chrome-plated rocker arms (standard up to February 1989)....
View Article1995 Ford Windstar Engine Front Cover REMOVAL AND INSTALLATION
download Engine Front Cover If the engine front cover (6019) is being removed to check timing chain deflection, refer to Timing Chain Deflection Procedure as outlined in Section 03-00. SPECIAL SERVICE...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article2006 Mazda5 BODY VIBRATION AT CRUISE SPEED
download DESCRIPTION Some vehicles may experience a body vibration when driving approximately 55mph. This symptom is due to the characteristics of the No. 3 & No. 4 engine mounts. Modified No. 3...
View Article2003 TOYOTA TACOMA TIMING BELT INSTALLATION REMOVAL
download NOTICE: Always turn the crankshaft clockwise. (c) Check that the timing marks of the camshaft timing pul- leys and No.3 timing belt cover are aligned. If not, turn the crankshaft pulley 1...
View Article2GR-FE Engine Ticking Noise and/or MIL “ON” P0014, P0015, P0024, P0025,...
download Introduction IMPORTANT It is mandatory that the VVT-i gear actuator bolts, actuator center section alignment, and actuator body be inspected BEFORE performing this TSB. If no concerns are...
View Article1996 Chevrolet Monte Carlo Camshaft Timing COMPLETE CAM TIMING PROCEDURE
download T] EXHAUST CAMSHAFT (RIGHT) T| INTAKE CAMSHAFT (RIGHT) T] SECONDARY TIMING BELT IDLER PULLEYS T) INTAKE CAMSHAFT (LEFT) 7] EXHAUST CAMSHAFT (LEFT) T] COOLANT PUMP T] INTERMEDIATE SHAFT BELT...
View Article